:  Nov 2, 2004



:
  This procedure is for removal and installation of the ignition lock cylinder. The ignition lock and door lock cylinders are replaced in sets.

. Fully extend the steering column for access.

. Remove the steering column upper shroud.
  Release the 4 clips.




. Remove the steering column lower shroud.
  Remove the 3 Torx screws.
  Release the steering column adjustment lever.




. Remove the passive coil.
  Disconnect the electrical connector.
  Release the 2 clips.

. Remove the ignition lock cylinder.
  Turn the ignition key to position 1.
  Insert a pin, not exceeding 2 mm diameter, through the access hole in the ignition lock cylinder housing to depress the plunger, and release the ignition lock cylinder.




. Install the ignition lock cylinder.
  Turn the ignition key to position 1.
  Locate into guides and depress the plunger.




. Install the passive coil.
  Secure the clips.
  Connect the electrical connector.

. Install the steering column shrouds.
  Tighten the Torx screws.
  Secure the clips.
  Secure the adjustment lever.